 |
| Boots heat molding procedures |
For all the boots you must use a convection oven (mandatory here that it has to be convection). Preheat the oven at 185F degrees. Put the skates in the oven for a period of 15-20 minutes. Put on the skate and tie them on like you do when you go skating. Stay in a sitting position without putting any pressure on the boots. Wait about 15 minutes. They are now molded. Wait at least 24 hours before using them.
Attention : before heating any boots make sure that they are made out of heat moldable material...See the manufacturer details or reseller information. The heat and the time could also vary depending on the boots.
*** FOR LG BOOTS :
Pre-heat the convection oven to 65 Celsius/150 Fahrenheit
(maximum). Place the boots in the oven for 30 minutes.
Put the boots on and tie them properly.
An elastic bandage can also be used to wrap the boot
tightly. Cool for at least 20 minutes. Don't use them for 24
hours.
***** FOR MAPLE BOOTS
The RST 7000 is almost not mouldable at all, only the ankle part.
For the Boots GST 90 and the MST 800:
· Heat convection oven at 100 degrees Celsius/212 F.
· Bake for 13-15 minutes.
· Cools down very fast so you have to handle quick.
· Everything is perfectly mouldable.
Hot water moulding procedure (when no oven available)
. You need : Plastic bag waterproof, water heater and Bucket.
. You heat the water and when it is 100 Celsius degrees you put it in the bucket.
After this you put the boot in the plastic bag and totally immerse it into the water.
You keep the boot there for 5-10min please check once and a while if it Is already soft enough.
When it is ready you put them on and rest for 20 mins. not moving.
|
|
|
